REVIEWMISSION 033 · PCB review · Release readinessIntermediate

Would You Release This PCB?

IO Controller Rev C has a clean DRC and is queued for fabrication. Review the board against its loaded electrical limits, connector-transient boundary, assembly access and released manufacturing notes. Block only the issues that violate a stated requirement, then choose a correction that removes each failure mechanism.

Requirements

Input · 24 VSwitched load · 2.0 APower drop · ≤100 mVTrace loss · ≤0.20 WUnprotected entry · ≤6 mmESD residual · ≤250 V
  1. 01Set the release disposition
  2. 02Build the release record
Circuit overview

Board package · Rev C

Release-review map

0 marked blockers
IO Controller Rev C release-review mapA four-layer controller PCB with six labeled review regions. Markers can be selected as release blockers.IO CONTROLLER · REV C4 LAYER · L2 SOLID GND · TOP COPPER REVIEWJ124 V INF1U2 · BUCK5 V / 1 AU1 · STM32CONTROL MCUR42Q12 A OUTJ2LOADGPIO_STATUS · 16 MHzJ3 · CANU4CAN PHYTVSJ5 · SWDENCLOSURE RIBABCDEFA–F: select each review region. Review the evidence before marking a release blocker.

The map combines PCB, fabrication and mechanical overlays. Select a marker to change its disposition; the evidence cards define the actual review boundary.

Circuit and case data
Circuit and case data
Prepared review evidence
A
24 V output neck-down

2.0 A · 72 mΩ · 144 mV drop · 0.29 W

Power-path limits: ≤100 mV drop and ≤0.20 W trace loss.
B
CAN protection branch

24 mm unprotected entry · 1.1 kV residual at the transceiver

Interface limits: ≤6 mm unprotected path and ≤250 V residual.
C
Programming-header access

Keyed SWD plug overlaps the enclosure rib by 3.5 mm

Firmware recovery must remain possible after enclosure assembly.
D
Two 90° GPIO corners

16 MHz GPIO · characterized 8 ns edge · continuous L2 ground · DRC passes

Project net class: GPIO; no controlled-impedance or corner-geometry rule is specified.
E
Vias in regulator thermal pad

Filled and capped per fabrication note F-07

Fabrication specification F-07 requires filled and capped thermal-pad vias.
F
Clipped R42 silkscreen reference

Reference remains legible on the controlled assembly drawing

Assembly requirement: component identity and placement must be readable in the controlled drawing package.
EVIDENCE INSPECTORReady to inspect

BOM / fabrication / assembly document

Inspect and save the original case evidence before making a decision.

Select an artifact, inspect its contents, then save the observation.

Evidence notebook 0 saved

No evidence saved yet. Measure, inspect the result, then save useful observations.

Current task
Current task

First inspect and save every original-case artifact to unlock the decision.

Step 1 of 2

Set the release disposition

Mark each real blocker on the board or below. Do not block a supported detail only because it looks unfamiliar.

0 evaluated reviews · Disposition and evidence saved locally
Technical references

Review boundary

The supplied DRC checks encoded geometry and connectivity rules. It cannot infer specified load current, cable/transient current paths, a keyed probe envelope or whether a released fabrication note makes a construction intentional.

Texas Instruments · PCB design guidelines and review context