REVIEWLIBRARY QA / MISSION 009Foundational

This Footprint Fits but the Pins Don't

U12 is a TMP117 temperature sensor in the 2 mm × 2 mm six-pin WSON package. The body fits the land pattern and the assembly drawing puts its pin-1 mark at the upper-left. Before fabrication, prove that the electrical pins also land on the intended nets.

Requirements

Part TMP117Package DRV · WSON-6Body 2.00 × 2.00 mmBoard view top sideRelease state pre-fabrication
  1. 01Follow pin 1
  2. 02Classify the fault
  3. 03Approve revision
Circuit overview
PCB + ASSEMBLY OVERLAY / Rev A · current release candidateVIEWED FROM TOP
U12TMP117ROTATION 0°EPPAD 6SDAP1PAD 5+3V3P2PAD 4ADD0P3PAD 3ALERTP4PAD 2GNDP5PAD 1SCLP6ASSEMBLY PIN-1 MARK
TERMINAL-TO-NET CROSS-CHECKREVIEW OPEN
IC / expected signalPCB padPCB net
P1 · SCLPad 6SDA
P2 · GNDPad 5V+
P3 · ALERTPad 4ADD0
P4 · ADD0Pad 3ALERT
P5 · V+Pad 2GND
P6 · SDAPad 1SCL

Trace the physical package terminal through the copper pad number to the schematic net. The body outline fitting is not an electrical check.

Simplified top-side review overlay. Copper geometry is illustrative and not a manufacturable land-pattern definition.

Current task
Current task
Technical references

Engineering notes

Three representations: a component library review must connect the manufacturer pin table, schematic pin numbers, PCB pad numbers, and assembly orientation.

Top versus bottom: never infer the drawing viewpoint. Here the manufacturer figure and the in-game PCB view are both explicitly top views.

Mechanical fit: the correct body size and pitch can still hide a destructive electrical mapping error. Review power and ground before treating bus pins as the only concern.

Production boundary: these teaching graphics are not land-pattern dimensions. Production libraries need the current manufacturer package drawing, fabrication rules, paste/mask review, and an independent library check.