BRING-UPLAB PRACTICE / MISSION 008Foundational

First Power-On

A newly assembled 12 V controller is ready for its first bench test. The expected idle current is 65–95 mA. Inspect it without power, resolve anything unsafe, then establish the documented idle baseline under a deliberate current limit before connecting a debugger.

Requirements

Input 12 V ±0.6 VExpected idle 65–95 mABaseline-gate limit 150 mA+5V range 4.75–5.25 V+3V3 range 3.20–3.40 V
  1. 01Pre-power checks
  2. 02Inspect + repair
  3. 03Controlled power
  4. 04Verify baseline
Circuit overview
POWER TREE / ASSEMBLED PCBSUPPLY OFF
VIN12 V INPUTU2 · BUCK12 V → 5 VU5 · LDO5 V → 3V3MCULOGICGNDC19 · 3V3 DECOUPLINGASSEMBLY AREATP1TP2TP3BENCH PSUOUTPUT OFF
Board de-energized. Use resistance mode only and allow capacitors to settle.
MEASUREMENT BENCHReady to measure
DMM / POWER OFFSettled resistance to GND

Protected 12 V input after the fuse and reverse-polarity stage.

Select a measurement target, then measure to inspect the result.

Evidence notebook 0 saved

No evidence saved yet. Measure, inspect the result, then save useful observations.

Current task
Current task
Technical references
Keysight · bench supply current limiting

The current limit and readings belong to this prepared board. All checks in this mission use the on-screen instruments.