DEBUGMISSION 026 · Grounding · Shared impedanceIntermediate

The Motor Shares Your Sensor's Ground

A remote pressure sensor is stable on the bench, but its reported value jumps whenever a 12 V motor runs. The sensor and motor share the same return conductor back to the controller. Determine whether the signal changed, or its reference did.

Requirements

Motor · 2.4 ASensor · 2.50 V localOriginal return · 65 mΩAllowed offset · ≤20 mV
  1. 01Remove the reference error
  2. 02Prove what moved
Circuit overview

Harness and reference path

Motor and pressure sensor return-current arrangementA remote motor and sensor connect to an MCU board. The selected revision either shares or separates their return conductors.MOTOR2.4 A runningSENSOR2.50 V localCONTROLLERU1 · SINGLE-ENDED ADC+12 VSENSOR SUPPLYPRESSURE SIGNALCOMMON RETURN IMPEDANCESHARED COPPERTP SENS GNDTP ADC GND

The pressure input is single-ended at U1. Its number depends on the signal conductor and the ground potential at the ADC, not only the voltage measured locally at the sensor.

Circuit and case data
Circuit and case data
Supplied load correlation
Shared resistance0.0650 ΩGround shift156.0 mVADC sees2.656 V

These are supplied lumped DC calculations for this harness. The shared-return resistance is a supplied lumped DC/common-impedance model. Positive offset means the remote sensor ground rises above ADC ground, so a sensor output defined relative to its local ground appears higher at the single-ended ADC. Inductive switching spikes, magnetic/radiated coupling, ADC sampling dynamics and chassis currents are outside this calculation.

MEASUREMENT BENCHReady to measure

First record motor-off offset, original motor-on offset and the local sensor output. The revised offset is available after evaluating the repair.

Select a measurement target, then measure to inspect the result.

Evidence notebook 0 saved

No evidence saved yet. Measure, inspect the result, then save useful observations.

Current task
Current task

Step 1 of 2

Find and remove the reference error

Measure and save the three original observations before selecting a diagnosis.

0 evaluated decisions · Draft and evidence saved locally
Technical references