DESIGNMISSION 012 · Digital logic · Level compatibilityFoundational

A High Level That Isn't High Enough

The prototype accepted a GPIO HIGH of 3.28 V at room temperature. Can you release a 3.3 V MCU command into a 5 V CMOS input across the specified operating range?

Requirements

MCU supply · 3.0–3.6 VReceiver supply · 4.5–5.5 VRequired margin · ≥0.20 V at every interface
  1. 01Find the missing guarantee
  2. 02Qualify the interface
Circuit overview

Explore the direct connection

3.3 V MCUVOH ≥ 2.70 V5 V receiverVIH ≥ 0.7 × VDD
Receiver logic thresholds and supplied output limitsAt 5.00 V receiver supply, LOW requires at most 1.50 V and HIGH at least 3.50 V. The path guarantees HIGH of at least 2.70 volts and LOW of at most 0.40 volts.0 V1 V2 V3 V4 V5 V6 VGUARANTEED LOWUNDEFINED LOGIC REGIONGUARANTEED HIGHVIH min · 3.50 VVIL max · 1.50 VVOH min · 2.70 VVOL max · 0.40 VStatic limits · no switching waveform
HIGH margin -0.80 VLOW margin 1.10 V
How to read these limits

These are guaranteed-limit comparisons, not measured switching traces. The bench sample is one observation, not a device envelope. The divider model neglects leakage optimistically; it already fails even with that advantage. This mission qualifies static guaranteed logic levels only. Dynamic timing, edge-rate requirements, signal integrity, startup sequencing, and powered-off behavior remain separate checks.

Circuit and case data
Circuit and case data
Guaranteed voltage limits
Supplied limits · −40 to +85°C · static load ≤10 µA
ParameterMCU outputReceiver input
HIGHVOH ≥2.70 VVIH ≥0.7 × VDD
LOWVOL ≤0.40 VVIL ≤0.3 × VDD
Voltage rangeOutput 0–3.60 VOperating input 0–VDD

Keep the MCU, receiver and push-pull command polarity. Their ground is common. Source limits cover loads up to 2 mA. Both rails are present before signaling; power-off and reset behavior are outside this release task.

HIGH margin = VOH(min) − VIH(min). LOW margin = VIL(max) − VOL(max). Stress limits do not define valid logic levels.

Current task
Current task

Step 1 of 2

Identify the missing guarantee

Select the worst receiver-supply corner on the left, then explain the direct interface's limiting condition.

0 evaluated decisions · Draft saved locally
Technical references