REVIEWMISSION 003 · PCB layout · Return pathsFoundational

Where Does the Current Come Back?

Rev A works on the bench, but a 20 MHz sensor clock is suspected in an emissions failure. Review the clock route and its reference before the next board spin.

Requirements

20 MHz SCLK2 ns edge timeL1 Components / SignalL2 Solid GND referenceL3 Power planeL4 SignalRequired isolation slotNo nearby reference-transfer element
  1. 01Locate
  2. 02Trace
  3. 03Revise
Circuit overview
CONTROL BOARD · REV AL1 routing with L2 reference overlay
42 × 28 mm
Four-layer control board layout A top-layer clock trace runs from the MCU on the left to a sensor on the right and crosses a vertical void in its layer-two ground reference. U1MCUSCLK SOURCEU4SENSORSCLK LOADC14GND VIASL2 VOIDKEEP-OUTSCLK · L1MISO · L1
L2 ground copper SCLK on L1
Current task
Current task
Technical references

Why the 2 ns edge matters

The 2 ns edges contain higher-frequency energy than the 20 MHz clock rate suggests. A continuous adjacent plane keeps the return close to SCLK; the void forces a larger loop.

Reference: TI, High-Speed Layout Guidelines (SCAA082A).

Model boundary

L2 is the intended high-frequency reference. Distributed parasitic paths do not make an interrupted reference plane equivalent to a deliberate return path.