DEBUGMISSION 037 · Power delivery · Voltage dropFoundational

The Connector Has Power, but the IC Doesn’t

A remote 24 V unit reports undervoltage at its internal IC even though a DMM shows power at the connector with the load disconnected. Rebuild the measurement under load, account for every series segment, and choose a cable/contact/PCB path that meets voltage and heating limits together.

Requirements

Source · 24 V nominalLow line · 21.60 VLoad · 1.5 AIC minimum · 21.00 VPath loss · ≤0.90 WContact loss · ≤0.20 W
  1. 01Repair the loaded path
  2. 02Prove power reaches the IC
Circuit overview

Loaded voltage ladder

Loaded source-to-IC power pathSource, cable loop, contact pair, PCB loop and IC pad are separate physical stages. Values below each stage are calculated loaded voltages.21.600 VCABLE LOOP420 mΩCONTACT PAIR160 mΩPCB LOOP180 mΩIC SUPPLY20.460 VAFTER CABLE20.970 VJ120.730 V1.50 A load currentLumped loop resistances include supply and return. V = IR · P = I²R

The supplied resistances are complete loop values at the stated operating condition. The diagram calculates a bounded DC path; it does not model connector aging, transient current or temperature feedback.

Circuit and case data
Circuit and case data
Path budget
Connector under load20.73 VIC under load20.46 VTotal resistance760 mΩTotal path loss1.71 W

A near-nominal open-circuit voltage proves continuity, not delivery. Each series element matters only when current turns its resistance into voltage drop and heat.

Measurement method

Use the simulated load and voltage captures below. Compare the source, connector and IC readings under the required load. The largest differential drop identifies the segment consuming margin.

EVIDENCE INSPECTORReady to inspect

Authored measurement capture

Inspect and save the original case evidence before making a decision.

Select an artifact, inspect its contents, then save the observation.

Evidence notebook 0 saved

No evidence saved yet. Measure, inspect the result, then save useful observations.

Current task
Current task

First inspect and save every original-case artifact to unlock the decision.

Step 1 of 2

Repair the complete loaded path

0 evaluated reviews · Plan and evidence saved locally
Technical references
OpenStax · Ohm’s law

Voltage drop uses V = IR; conductor heating uses P = I²R. Resistances and acceptance limits are supplied case data.