DESIGNMISSION 031 · Inductive loads · Clamp designIntermediate

Stop the Inductive Kick

A 24 V solenoid turns off through a 60 V low-side MOSFET. The original board reaches 82 V, while a plain flyback diode lets coil current decay too slowly. Design a turn-off path that protects the switch, meets the electrical decay limit, and survives the stored energy.

Requirements

Coil · 120 mH / 24 ΩCurrent · 1.0 AMOSFET · 60 VDesign VDS · ≤50 VCurrent to zero · ≤5 ms Stored energy · 60 mJ
  1. 01Balance clamp tradeoffs
  2. 02Verify turn-off
Circuit overview

Turn-off energy path

Low-side solenoid driver with turn-off clamp 24 V feeds the coil, then Q1 drain; Q1 source connects to ground. D1 connects across the coil. D1 cathode faces 24 V. Turn-off current flows down the coil and up the clamp branch.+24 VSOLENOID120 mH · 24 ΩDSGQ1 · 60 VN-MOSGATE · OFFD10.7 V total clampVDS ≤ 50 VCurrent to zero ≤ 5 msNetwork pulse rating ≥ 90 mJD1 CATHODE TOWARD +24 V

An ideal R-L model uses fixed 120 mH inductance, 24 Ω resistance and 1 A initial current. Clamp choices specify total reverse voltage across the coil, including D1; they are not nominal TVS part numbers. D1 blocks normal drive, and the series TVS avalanches at turn-off. The original and prototype captures are independent authored scenario records.

Circuit and case data
Circuit and case data
Calculated design window
Clamp level 0.7 V MOSFET VDS 24.7 V Current to zero 17.82 ms Required pulse energy 90 mJ

Time to zero current: t = (L/R) ln(1 + R·I₀/Vclamp). VDS = 24 V + Vclamp. Stored energy = ½L·I₀². The 5 ms requirement is electrical demagnetization; actuator motion is outside this model. The 90 mJ pulse requirement conservatively includes all stored energy with 1.5× margin. The 50 V design ceiling leaves 10 V below the 60 V rating for clamp tolerance, parasitic overshoot and switching behavior; that margin still needs hardware qualification.

EVIDENCE INSPECTORReady to inspect

Authored measurement capture

Inspect and save the original case evidence before making a decision.

Select an artifact, inspect its contents, then save the observation.

Evidence notebook 0 saved

No evidence saved yet. Measure, inspect the result, then save useful observations.

Current task
Current task

First inspect and save every original-case artifact to unlock the decision.

Step 1 of 2

Balance protection and current decay

0 evaluated decisions · Draft and evidence saved locally
Technical references

Design boundary

Integrated solenoid drivers similarly treat current regulation, recirculation and clamp behavior as part of the power path. This mission keeps the driver discrete so the stress, current-decay and energy tradeoff remains visible. Clamp voltage is an ideal constant reverse voltage across the coil and the pulse-energy choices are supplied network qualifications for this exact single-pulse envelope. They are not generic TVS datasheet energy ratings. Real selection requires clamp tolerance/dynamic resistance, pulse shape and repetition, temperature derating, parasitic overshoot, MOSFET SOA/avalanche and actuator tolerance.

Analog Devices · diode-plus-Zener demagnetization (Figure 4)