REVIEWMISSION 029 · PCB layout · Switching powerIntermediate

Keep the Switch Node Away From My Signal

A 24 V to 5 V buck converter regulates at DC, but its feedback pin and output show edge-correlated spikes. Review the energy paths, the switch-node copper and the sensitive sense route. Use the original local captures before committing a revision.

Requirements

Input · 24 VOutput · 5 VSwitching · 400 kHzEdge · 5 nsFB noise · ≤10 mVppOutput · ≤30 mVpp
  1. 01Control the aggressor
  2. 02Prove the coupling path
Circuit overview

Power-stage board review

Buck-converter power and feedback layoutA simplified board view shows the input commutation loop, switch-node copper, output components and the selected feedback route.TOP COPPER · REV-ACIN24 VQHQLPULSED INPUT COMMUTATION LOOPSWHIGH dv/dtL1COUTFB DIVIDERCONTROLFB

FB is the controller's feedback input. The divider connects here; the SW node does not.

The drawing separates the pulsed input commutation loop, exposed high-dv/dt SW copper, filtered output and feedback victim. Geometry is simplified; the comparison captures below are supplied board characterization.

Circuit and case data
Circuit and case data
Characterized revision comparison
SW copper120 mm²FB geometry0.6 mm lateral · top layerFB noise68 mVppOutput switching disturbance140 mVpp

These fixed values compare three prepared boards. They are not calculated from distance by an arbitrary electromagnetic or control-loop simulator.

MEASUREMENT BENCHReady to measure

First establish correlation between the original SW edge, FB disturbance and local COUT disturbance. Verify the revision after evaluating the layout.

Select a measurement target, then measure to inspect the result.

Evidence notebook 0 saved

No evidence saved yet. Measure, inspect the result, then save useful observations.

Current task
Current task

Step 1 of 2

Control the aggressor and protect the victim

Measure and save the three original observations before selecting a diagnosis.

Rev A
120 mm² SW copper; FB on the top layer, 0.6 mm beside SW.
Rev B
95 mm² SW copper; FB on the bottom layer under SW, separated by 0.2 mm of dielectric.
Rev C
28 mm² SW copper; FB on the top layer, 8 mm away from SW.

Probe only SW relative to a remote ground clip

0 evaluated decisions · Draft and evidence saved locally
Technical references